Site measure and slope check
Measure the driveway opening width, assess the slope grade at the gate line, and confirm post locations and setbacks — slope determines whether swing or slide is practical.
Lower Mainland
Driveway Gates in Burnaby
Burnaby driveway gates serve established homes in Deer Lake and South Slope as well as newer builds in Capitol Hill and Burnaby Mountain where security, curb appeal, and automation are usually all part of the brief. The range of lot types across Burnaby — from compact infill to larger single-family lots — means post placement and swing geometry need to be confirmed on site.
A good gate looks intentional and operates cleanly. Frame stiffness, hinge posts, slope, automation planning, and finish selection all matter before the steel is cut.
What matters in Burnaby
Burnaby mixes custom homes, strata towers, institutional projects, and commercial spaces, which makes it a strong fit for both residential stairs and repeatable railing packages.
- Capitol Hill and Burnaby Mountain properties with steeper driveways may need careful hinge post sizing and counterbalanced leaf design.
- Burnaby's permit requirements for new gates depend on whether the property is single-family, strata, or commercial — confirm the authority before shop drawings.
- Automation motor sizing should account for the gate leaf weight plus the driveway grade if any slope is present.
Common configurations
- Swing and slide driveway gates
- Pedestrian gates matched to fencing
- Modern slat, picket, or panel designs
- Automation-ready steel frames
Budget ranges
| Scope | Typical range | Notes |
|---|---|---|
| Manual pedestrian or small driveway gate | $4,500-$12,000 | Simple steel design |
| Custom double swing gate | $12,000-$30,000 | Posts, hinges, and finish included |
| Automation-ready gate package | $25,000-$55,000+ | Automation by specialist coordination |
Process
Automation planning
If automation is required, coordinate the motor specification with the gate fabricator before steel sizing is confirmed — the motor's duty cycle and torque rating affect the frame weight target.
Gate frame fabrication
Fabricate the gate frame with appropriate tube sizing for the span, weld infill panels or slats, and fit-check the gate against the post template in the shop.
Hinge post setting
Set hinge posts in concrete with correct offset for the gate swing arc; posts must be plumb and in-line before the gate is hung.
Gate hang, finish, and automation install
Hang and adjust the gate, apply powder coat or primer in the shop before delivery, and coordinate automation motor installation with the specialist.
Local conditions
1.6 kPa reference value for early planning. Final engineering confirms project-specific assumptions.
none exposure. Finish and hardware choices should follow the exact site conditions.
New stairs, altered guards, and structural steel attachments generally need permit or engineer review.
FAQ
Planning questions for Burnaby
How much do driveway gatess cost in Burnaby?
Driveway Gates pricing depends on dimensions, railing type, finish, access, and engineering. Current planning ranges on this page run from $4,500-$12,000 depending on scope.
How long does a driveway gates project take from quote to installation in Burnaby?
Most driveway gates projects run 6–10 weeks from a confirmed order: 1–2 weeks for shop drawings and engineer review, 3–5 weeks in fabrication, and 1–2 weeks for finishing and installation scheduling. Burnaby site access and permit timing can shift that window, so starting the quote early gives the most flexibility.
What information helps get an accurate Burnaby quote?
Floor-to-floor height or linear footage, site photos, any existing drawings, finish preference, and whether a permit has been applied for. For Burnaby projects, confirming the finish and connection details early avoids changes after shop drawings are approved.
Start a project
Plan a driveway gates project in Burnaby
Send drawings, photos, or a rough scope and we will help define the practical next step.