Site measure and slope check
Measure the driveway opening width, assess the slope grade at the gate line, and confirm post locations and setbacks — slope determines whether swing or slide is practical.
Tri-Cities
Driveway Gates in Coquitlam
Coquitlam driveway gates serve new builds on Burke Mountain and established properties in Westwood Plateau and Ranch Park where homeowners want to define the property edge and add security without a heavy visual presence. The active local building market means gate projects often run on builder or developer timelines.
A good gate looks intentional and operates cleanly. Frame stiffness, hinge posts, slope, automation planning, and finish selection all matter before the steel is cut.
What matters in Coquitlam
Coquitlam has active new-build and renovation markets, especially for modern stairs, glass railings, and exterior metalwork.
- Burke Mountain new-build lots are often larger than typical Lower Mainland infill — longer driveway spans may need a slide gate or double-leaf swing to match the opening width.
- City of Coquitlam permit requirements for new gates and fences should be confirmed before shop drawings are issued.
- Automation scoping should happen at the design stage — motor type, electrical rough-in, and battery backup are easier to plan before the post is set.
Common configurations
- Swing and slide driveway gates
- Pedestrian gates matched to fencing
- Modern slat, picket, or panel designs
- Automation-ready steel frames
Budget ranges
| Scope | Typical range | Notes |
|---|---|---|
| Manual pedestrian or small driveway gate | $4,500-$12,000 | Simple steel design |
| Custom double swing gate | $12,000-$30,000 | Posts, hinges, and finish included |
| Automation-ready gate package | $25,000-$55,000+ | Automation by specialist coordination |
Process
Automation planning
If automation is required, coordinate the motor specification with the gate fabricator before steel sizing is confirmed — the motor's duty cycle and torque rating affect the frame weight target.
Gate frame fabrication
Fabricate the gate frame with appropriate tube sizing for the span, weld infill panels or slats, and fit-check the gate against the post template in the shop.
Hinge post setting
Set hinge posts in concrete with correct offset for the gate swing arc; posts must be plumb and in-line before the gate is hung.
Gate hang, finish, and automation install
Hang and adjust the gate, apply powder coat or primer in the shop before delivery, and coordinate automation motor installation with the specialist.
Local conditions
1.8 kPa reference value for early planning. Final engineering confirms project-specific assumptions.
none exposure. Finish and hardware choices should follow the exact site conditions.
Structural stair and guard work should be aligned with City of Coquitlam requirements before fabrication.
FAQ
Planning questions for Coquitlam
How much do driveway gatess cost in Coquitlam?
Driveway Gates pricing depends on dimensions, railing type, finish, access, and engineering. Current planning ranges on this page run from $4,500-$12,000 depending on scope.
How long does a driveway gates project take from quote to installation in Coquitlam?
Most driveway gates projects run 6–10 weeks from a confirmed order: 1–2 weeks for shop drawings and engineer review, 3–5 weeks in fabrication, and 1–2 weeks for finishing and installation scheduling. Coquitlam site access and permit timing can shift that window, so starting the quote early gives the most flexibility.
What information helps get an accurate Coquitlam quote?
Floor-to-floor height or linear footage, site photos, any existing drawings, finish preference, and whether a permit has been applied for. For Coquitlam projects, confirming the finish and connection details early avoids changes after shop drawings are approved.
Start a project
Plan a driveway gates project in Coquitlam
Send drawings, photos, or a rough scope and we will help define the practical next step.