Site measure and slope check
Measure the driveway opening width, assess the slope grade at the gate line, and confirm post locations and setbacks — slope determines whether swing or slide is practical.
North Shore
Driveway Gates in North Vancouver
North Vancouver driveway gates often serve hillside homes in Lynn Valley, Edgemont, and Upper Lonsdale where steep driveways, wetter conditions, and design-conscious owners all shape the brief. The North Shore's higher rainfall and moderate coastal exposure mean finish durability is part of the specification from day one.
A good gate looks intentional and operates cleanly. Frame stiffness, hinge posts, slope, automation planning, and finish selection all matter before the steel is cut.
What matters in North Vancouver
North Vancouver stair and railing work often serves steep lots, view homes, wetter weather, and waterfront exposure.
- Steep hillside driveways in Edgemont and Upper Lonsdale require careful hinge post engineering — a heavy leaf on a steep grade puts significant load on the hinge and motor.
- Higher North Shore rainfall means all hardware, hinges, and automation components should be rated for wet-environment use.
- Permit requirements differ between the District and City of North Vancouver — confirm the jurisdiction and applicable bylaw before finalizing gate dimensions.
Common configurations
- Swing and slide driveway gates
- Pedestrian gates matched to fencing
- Modern slat, picket, or panel designs
- Automation-ready steel frames
Budget ranges
| Scope | Typical range | Notes |
|---|---|---|
| Manual pedestrian or small driveway gate | $4,500-$12,000 | Simple steel design |
| Custom double swing gate | $12,000-$30,000 | Posts, hinges, and finish included |
| Automation-ready gate package | $25,000-$55,000+ | Automation by specialist coordination |
Process
Automation planning
If automation is required, coordinate the motor specification with the gate fabricator before steel sizing is confirmed — the motor's duty cycle and torque rating affect the frame weight target.
Gate frame fabrication
Fabricate the gate frame with appropriate tube sizing for the span, weld infill panels or slats, and fit-check the gate against the post template in the shop.
Hinge post setting
Set hinge posts in concrete with correct offset for the gate swing arc; posts must be plumb and in-line before the gate is hung.
Gate hang, finish, and automation install
Hang and adjust the gate, apply powder coat or primer in the shop before delivery, and coordinate automation motor installation with the specialist.
Local conditions
1.8 kPa reference value for early planning. Final engineering confirms project-specific assumptions.
high exposure. Finish and hardware choices should follow the exact site conditions.
District and City requirements differ; structural changes, guards, and canopies commonly need review.
FAQ
Planning questions for North Vancouver
How much do driveway gatess cost in North Vancouver?
Driveway Gates pricing depends on dimensions, railing type, finish, access, and engineering. Current planning ranges on this page run from $4,500-$12,000 depending on scope.
How long does a driveway gates project take from quote to installation in North Vancouver?
Most driveway gates projects run 6–10 weeks from a confirmed order: 1–2 weeks for shop drawings and engineer review, 3–5 weeks in fabrication, and 1–2 weeks for finishing and installation scheduling. North Vancouver site access and permit timing can shift that window, so starting the quote early gives the most flexibility.
What information helps get an accurate North Vancouver quote?
Floor-to-floor height or linear footage, site photos, any existing drawings, finish preference, and whether a permit has been applied for. For North Vancouver's high coastal exposure, confirming the hardware specification early avoids changes after shop drawings are approved.
Start a project
Plan a driveway gates project in North Vancouver
Send drawings, photos, or a rough scope and we will help define the practical next step.