Site measure and slope check
Measure the driveway opening width, assess the slope grade at the gate line, and confirm post locations and setbacks — slope determines whether swing or slide is practical.
Fraser Valley
Driveway Gates in Surrey
Surrey driveway gates serve properties from South Surrey acreages to Morgan Creek estates where the gate is often the first impression of the property. Frame stiffness, hinge posts, and automation planning all matter before the steel is cut.
A good gate looks intentional and operates cleanly. Frame stiffness, hinge posts, slope, automation planning, and finish selection all matter before the steel is cut.
What matters in Surrey
Surrey projects range from custom homes and gates to strata railing programs and commercial stair packages.
- Larger lots in South Surrey and Cloverdale often allow for wider double-swing or slide gate configurations.
- Automation should be coordinated with the gate fabricator, not added after the fact.
Common configurations
- Swing and slide driveway gates
- Pedestrian gates matched to fencing
- Modern slat, picket, or panel designs
- Automation-ready steel frames
Budget ranges
| Scope | Typical range | Notes |
|---|---|---|
| Manual pedestrian or small driveway gate | $4,500-$12,000 | Simple steel design |
| Custom double swing gate | $12,000-$30,000 | Posts, hinges, and finish included |
| Automation-ready gate package | $25,000-$55,000+ | Automation by specialist coordination |
Process
Automation planning
If automation is required, coordinate the motor specification with the gate fabricator before steel sizing is confirmed — the motor's duty cycle and torque rating affect the frame weight target.
Gate frame fabrication
Fabricate the gate frame with appropriate tube sizing for the span, weld infill panels or slats, and fit-check the gate against the post template in the shop.
Hinge post setting
Set hinge posts in concrete with correct offset for the gate swing arc; posts must be plumb and in-line before the gate is hung.
Gate hang, finish, and automation install
Hang and adjust the gate, apply powder coat or primer in the shop before delivery, and coordinate automation motor installation with the specialist.
Local conditions
1.6 kPa reference value for early planning. Final engineering confirms project-specific assumptions.
none exposure. Finish and hardware choices should follow the exact site conditions.
Large sites and multi-family scopes benefit from early permit and drawing coordination.
FAQ
Planning questions for Surrey
How much do driveway gatess cost in Surrey?
Driveway Gates pricing depends on dimensions, railing type, finish, access, and engineering. Current planning ranges on this page run from $4,500-$12,000 depending on scope.
How long does a driveway gates project take from quote to installation in Surrey?
Most driveway gates projects run 6–10 weeks from a confirmed order: 1–2 weeks for shop drawings and engineer review, 3–5 weeks in fabrication, and 1–2 weeks for finishing and installation scheduling. Surrey site access and permit timing can shift that window, so starting the quote early gives the most flexibility.
What information helps get an accurate Surrey quote?
Floor-to-floor height or linear footage, site photos, any existing drawings, finish preference, and whether a permit has been applied for. For Surrey projects, confirming the finish and connection details early avoids changes after shop drawings are approved.
Start a project
Plan a driveway gates project in Surrey
Send drawings, photos, or a rough scope and we will help define the practical next step.